Skip to main content
Laser cleaning sample collage from Bay Area demo and job work
Testyourmaterialonsite.

Free On-Site Laser Cleaning Demo | Bay Area

A free 60-minute on-site demo in the San Francisco Bay Area. We bring a Netalux laser to your place, test your actual material, and you see the result before you rent or book work. Schedule a visit.

See the result on your material before you decide

The visit is free and runs about 60 minutes. Coverage is the San Francisco Bay Area. We set up on your site, run a short pass on a piece you care about, and you judge the surface yourself. No commitment to rent or book a technician.

How the visit works

  • Book a slot through the contact form or call (650) 590-5040.
  • Have a sample ready, a panel, a rail, a wood piece, or a part that shows the rust, paint, or finish you want removed.
  • We arrive with a machine, set a safe zone, and clean a test area while you watch.
  • You decide next, rent the Kamino 300 or Dagger 4000, add a technician, or stop there.

Wood finish tests

If the coating on the wood is unknown, run one test the day before. Water-based polyurethane and acrylic lacquer sit on the surface and reflect the beam, so the wood underneath can overheat before the coating lifts. Either test is enough.

Water drop test

  • Place one small drop of water on an inconspicuous area and wait 60 seconds. A water-based finish (polyurethane, acrylic lacquer) will bead or sit on the surface. An oil-based finish or bare wood will absorb it quickly, darkening the grain.

Alcohol swab test

  • Dampen a cotton swab with 91% or higher isopropyl alcohol and rub a small hidden area firmly for 10 seconds. Lacquer softens and smears. Polyurethane and conversion varnish show no effect.
  • Shellac and soft lacquer need the lowest energy of any wood finish. Naming them ahead of time keeps decorative and antique pieces from scorching.

Wood

The carving stays sharp, and the grain is not sanded. Stain and varnish lift off a deck, door, table, or carved rail without a chemical stripper soaking in.

Masonry

Tool marks and mortar lines stay. Paint and weather stains leave brick, granite, marble, and concrete without the wear blasting and grinding leave behind.

Rust

The steel stays ready to inspect, coat, or bond. Surface rust, mill scale, and weld discoloration leave doors, rails, hardware, and light automotive parts without a ground profile or blast media.

Paint

The substrate stays intact. Paint and coatings lift from metal, wood, and masonry without abrasive media or solvent waste.

FAQ

  • Is the on-site demo free?

    Yes. The on-site demo is free for about 60 minutes in the San Francisco Bay Area. You are not required to rent or book a technician afterward.

  • What should I have ready for the demo?

    Have a sample of the material and contaminant you care about, room to park and set up, and power access if the site needs it. Clear a small work zone so we can mark a safe area and run a short test pass.

  • When should I run the wood finish tests?

    When the job includes wood with an unknown coating, run one test on this page before arrival. A water drop or a 91 percent isopropyl swab on a hidden spot tells whether the contaminant is water-based, oil-based, or a soft lacquer. Either test is enough.

  • Which machine do you bring to the demo?

    We match the machine to your material and job size. Home, shop, and detailed parts usually use the Kamino 300. Heavy industrial and structural work usually uses the Dagger 4000. Machine details are on the Kamino and Dagger pages.

  • What happens after the demo?

    You decide. Rent a machine with delivery, setup, and training, add a technician day rate, or stop with the test result. Rates are on the rentals page.